Dynex DX-22L150A11 펌웨어 업데이트
{카테고리_이름} Dynex DX-22L150A11에 대한 펌웨어 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynex DX-22L150A11 3 페이지. Tv acl de 15/19/22 po
Dynex DX-22L150A11에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지), (빠른 설치 가이드 (2 페이지), (프랑스어) 빠른 설치 매뉴얼 (2 페이지)
페이지 인쇄
Firmware update: Download/Install instructions for TV Models: DX‐15L150A11,
System requirements: a computer with an open USB port, USB 2.0 flash drive (stick), broadband
internet access and operating software of Windows XP, Windows Vista, Windows 7 or Mac OS 10.3 or
newer. This option is not recommended with dial‐up or DSL service with a bit rate lower than 256kbps. If
the instructions provided below do not help, call Dynex Customer Support at (800) 305‐2204 for
assistance.
First: Download the update file
1. Determine the Model number of your TV located on the back, bottom or side of TV (see photos
below)
2. Insert USB flash drive into the open USB port on your computer.
3. Verify that you are on the support tab of your product model number; then click on the
firmware link.
4. Download firmware; if a pop‐up window opens telling you to open, save or cancel, click Save
and save the file to your USB flash drive. Note: File needs to be saved on the root directory.
a. Note: File size is approximately 3 MB. Estimated download time is 1‐2 minutes (with a
1.5 Mbps broadband connection).
5. After saving the firmware to your USB flash drive; remove the USB flash drive from your
computer.
Second: Upgrading the TV Software with a USB Flash Drive (Stick)
1. Make sure you TV's AC cord is securely plugged into a wall outlet and the unit is turned off. This
can be verified by a red indicator light on the front of the TV.
2. Insert the USB flash drive containing the firmware that was downloaded into the TV's USB
service port located on the side of the TV. Note: This port maybe covered by a rubber flap, you
may need to flip open the rubber flap (See photo below).
DX‐19L150A11, DX‐22L150A11, DX‐40L150A11
Label
Back
Side or Bottom Label