Coral 613 설치 매뉴얼 - 페이지 5

{카테고리_이름} Coral 613에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coral 613 8 페이지. Ion exchange water softener

The main user guide should only be used for reference purposes, please use this guide

Your Softener should already have been set up with the basic settings in the factory!

The only settings you should need to enter are the time of day, day of week and the water

Before starting this process ensure that the softener is connected correctly to the water and

power supplies.

Initial Power Up.

Plug the transformer into the rear of the control panel; this is located to the

left top corner of the panel if viewing from the front. Once the power is

connected the display should show 255, on occasions the display may

flash between time and regeneration with the regen symbol flashing, press

set button to clear. During the set up process the display may revert to

service mode (after 25 seconds) by repeatedly pressing the set button you

can scroll to the part of the set up programme you require. If you receive

an ERR3 message allow the cam shaft to turn for a few moments and this

code should disappear. If the cam does not move Check that the Cam

Shaft is fitted correctly and that the optical sensor is in position.

Set Time.

Press the set button. The TIME should now be flashing, use the up and

down arrows to set the correct time of day (24hrs format). Once the

correct time has been selected, press the set button to confirm. The

following will then be displayed.

Set Day of the Week.

Press the set button to display the screen shown. The display will flash,

use the up and down buttons to advance the arrow to underneath the

correct day. Once under the correct day press the set button to confirm.

The following will then be displayed.

Quick Set Up Guide

for initial programming.

hardness

1. Down arrow. Used to scroll down or

increment through a group of choices.

2. Set. Used to accept a setting to store in the

memory.

3. Up arrow. Used to scroll up or increment up

through a group of choices.

4. Regenerate. Used to command the controller

to regenerate.

- 5 -