Dynex DX-CR212 자주 묻는 질문 - 페이지 2

{카테고리_이름} Dynex DX-CR212에 대한 자주 묻는 질문을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynex DX-CR212 5 페이지. Lecteur de carte mémoire 11-en-1
Dynex DX-CR212에 대해서도 마찬가지입니다: 매뉴얼 (6 페이지), 사용자 설명서 (13 페이지), 빠른 설정 매뉴얼 (2 페이지), (영어) 사용자 가이드 (13 페이지), (프랑스어) 매뉴얼 드 뤼용자 (13 페이지)

페이지 인쇄

Setup Questions

Question 1: How do I set up my card reader using Windows XP, Vista, or 7?

1. Plug the USB cable into an open USB port on your computer.

2. Insert a card into the appropriate slot. The blue LED lights.

Caution: Cards must be inserted into the correct slot and in the correct direction; otherwise,

you may damage the card and/or the slot.

§ Cards must be inserted label side down into the SD slot.

§ Cards must be inserted label side up in the MS and microSD slots.

3. Click Start, then click My Computer/Computer.

4. Double-click the appropriate drive to access the data on the memory card.

Question 2: How do I set up my card reader on a Mac?

1. Plug the USB cable into an open USB port on your Mac.

2. Insert a card into the appropriate slot. The blue LED lights and a new icon appears on the

desktop.

Caution: Cards must be inserted into the correct slot and in the correct direction; otherwise,

you may damage the card and/or the slot.

§ Cards must be inserted label side down into the SD slot.

§ Cards must be inserted label side up in the MS and microSD slots.

3. Double-click the new icon to access the data on the memory card.

Question 3: New Removable Disks do not appear in My Computer/Computer when I

connect my card reader to a Windows PC.

Make sure that your memory card is fully inserted into the slot on the card reader.

Make sure the card reader is connected to your computer. Unplug and reconnect your

USB cable.

Try a different memory card of the same type in the same slot. If a different memory card

works, the original memory card should be replaced.

Disconnect the USB cable from your card reader and shine a flashlight into the empty

card slots. Look to see if any pin inside is bent, then straighten bent pins with the tip of a

mechanical pencil. Replace your memory card reader if a pin has bent so much that it

touches another pin.

Unplug your card reader from the USB port and restart your computer. Reconnect your

card reader to your computer.

Question 4: When I insert a card into the card reader, no icon appears on my Mac