Galvin Engineering Ezy-Drink 35188X 설치 매뉴얼 - 페이지 2
{카테고리_이름} Galvin Engineering Ezy-Drink 35188X에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Engineering Ezy-Drink 35188X 3 페이지. Ss remote drinking bubbler tap mouth guard and stem
페이지 인쇄Product Installation Guidelines
PRE-INSTALLATION -
−
If the mounting holes do not already exist, mark out and drill
the holes in the bench/trough, as shown in rough-in
dimensions.
Note: Before installation, all lines must be flushed.
We recommend that a line strainer be installed prior to drinking
taps to eliminate any foreign material.
INSTALLATION
IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and in
accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions
must also comply to the applicable national and/or state standards. Failing to comply with these provisions shall void the
product warranty and may affect the performance of the product.
1. Disassemble Mouthguard Outlet
−
Remove back nut and cup washer from the
mouthguard outlet assembly
© Galvin Engineering Pty Ltd
MOUNTING DETAILS
2. Fit Mouthguard Outlet
−
Ensure the sealing rubber washers are placed
underneath the mouthguard outlet.
−
Fit the mouthguard outlet into the trough.
th
Version 1, 25
October 2022, Page 2 of 3
th
Version 2, 12
July 2022, Page 2 of 3
Rough-In Dimensions
*Only drill Ø2.5mm hole if anti-
rotation pin (not supplied) is
required.