Dynex DX-E202 자주 묻는 질문 - 페이지 3
{카테고리_이름} Dynex DX-E202에 대한 자주 묻는 질문을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynex DX-E202 4 페이지. User manual (french)
Dynex DX-E202에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), (설치 가이드 (16 페이지), (프랑스어) 설치 가이드 (16 페이지)
페이지 인쇄
interference. Once you have determined which device is causing interference, please move it
further from the network to eliminate the interference.
Verify each computer's identification. How do users find the work group name?
1. Make sure that each computer on your network has a unique computer name.
2. Make sure that the workgroup name is identical for all computers on your network. If one
computer had a different workgroup name than the others, that computer will not appear in the
same workgroup view.
Verify Indicators.
1. Your network card has indicators or lights that can give you information about your network
traffic. The card has two indicators labeled Link/Act and Full Duplex. A steady green Link/Act
light indicates that the network card is sending or receiving data. A steady green Full Duplex
light indicates that the card is operating in full duplex.
2. When your computer is turned On and the network card is inserted into an open slot connector,
a green light on the direct port LED indicator (this is a LED that is in the port where you connect
an Ethernet cable to the network card) indicates that the card is linked to the network. If the
LED remains dark without any apparent cause, check the network card installation.
Ping your network card.
Locating the computer name:
For Windows, click Start, then right-click My Computer (or Computer), click
Properties. It will be listed under 'Computer Name, Domain, and Workplace
Settings'.
For Mac, click Apple menu, and choose System Preferences, click
Sharing, it is listed following Computer Name.
Locating the workgroup name:
For Windows, click Start, then right-click My Computer (or Computer), click
Properties. It will be listed under 'Computer Name, Domain, and Workplace
Settings'.
For Mac, click Apple menu, and choose System Preferences, click
Sharing, choose Ethernet and click Advanced..., then click WINS, it is
listed follow Workgroup.
By sending out a Ping, you are verifying that a specific computer is available.
Because all computers on the network must have a unique IP address, getting a
reply means that a computer is on the network and it can communicate. If the
computers can communicate, the hardware and cabling are probably okay. If you
cannot ping another computer, there is probably a problem with the hardware. Check
the cabling and adapter installation. If you are unable to network, even when you
receive a reply to your ping, there is probably a software configuration problem.
Verify that all the settings are correct.
To Ping the network card:
1. Click Start, then click Run. The Run dialog box opens.
2. Type cmd in the Open box, then click OK. The command window
opens.
3. Type ping www.google.com.
4. Press Enter to begin pinging. If the connection is good, you receive
continuous 'Reply from' messages. If you receive another message, it
means you are not getting a good connection and you should contact
your ISP for help.
5. Type exit at the prompt to return to Windows or press Ctrl+C.
3