AGS Merlin 1000Si 사용자 설명서 - 페이지 9

{카테고리_이름} AGS Merlin 1000Si에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Merlin 1000Si 12 페이지. Gas safety products, gas utility controller
AGS Merlin 1000Si에 대해서도 마찬가지입니다: 사용자 및 설치 매뉴얼 (7 페이지), 사용자 및 설치 매뉴얼 (9 페이지), 설치 및 운영 매뉴얼 (16 페이지)

AGS Merlin 1000Si 사용자 설명서
Merlin 1000Si
Timeout
Under normal working conditions this LED is off. This LED will illuminate AMBER when auto-shut
down has occurred.
OFF = OK
ON = auto-shut down
EM Stop
If an emergency shut off button (either remote or on the panel) is pressed, the LED will
illuminate AMBER and the gas will be turned off. The EM Stop button must be re-set before
restarting the system.
OFF = OK
ON = EM Stop button pressed.
Gas Detected
Under normal working conditions this LED is off. If the external Merlin detector connected
detects gas this will show RED and the Gas valve will turn off.
OFF = OK
ON = Gas detected.
CO
High
2
Under normal working conditions this LED is off. If the concentration of CO2 in the air is at alarm
level (relevant detector required), the LED will show RED and the Gas valve will turn off.
OFF = OK
ON = the concentration of CO2 is at alarm level.
5

Maintenance

To keep your panel in good working order, you must follow these steps:
 DO carefully remove any accumulated dust from the outer enclosure once a month.
NEVER use detergents or solvents to clean your device – this may permenantly or temporarily
damage the panel
NEVER spray air fresheners, hair spray, paint or other aerosols near the device.
NEVER paint the device. Paint will seal vents and interfere with the device.
Rev: 05
05-19
User Guide
9