Galvin Engineering Haws 7777-A 제품 설치 매뉴얼 - 페이지 5

{카테고리_이름} Galvin Engineering Haws 7777-A에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Engineering Haws 7777-A 7 페이지. Pedestal floor mtd, axion msr eye/face wash head, s/s bowl, hand & foot act
Galvin Engineering Haws 7777-A에 대해서도 마찬가지입니다: 제품 설치 매뉴얼 (6 페이지)

페이지 인쇄

TROUBLESHOOTING

PROBLEM

1. No Flow.

2. Insufficient water flow

3. Eye/face wash streams do not meet

desired eye level.

4. Water does not drain properly.

For more information about GalvinSafe

Check the main shut-off valve.

2. a. Verify minimum 210 kPa flowing

supply line pressure.

b. Probable clogging of flow control due

to inadequate line flushing. Unscrew

eye/face wash head and remove the

four screws to disassemble head.

Clean flow control and reassemble

Head.

c. Remove plug located on L – Strainer

using a 9/16" wrench to access clean

filter screen.

3. Possible blocked flow control, see above

solution. Possible non-leveled eye/face

wash assembly

4. Check the main waste line of your

building to see if it does handle the

capacity required for the entire drainage

system.

(Haws) products, see our website.

Version 4.1, 13

Aug. 2021, Page 5 of 7

REPAIR CHECKLIST