Dynex DX-DRTVM114 조립 설명서 - 페이지 12
{카테고리_이름} Dynex DX-DRTVM114에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynex DX-DRTVM114 15 페이지. Support mural discret pour téléviseurs
Dynex DX-DRTVM114에 대해서도 마찬가지입니다: (영어) 수동 조립 가이드 (15 페이지), (프랑스어) 매뉴얼 드 몽타주 (15 페이지)
페이지 인쇄12
STEP 6 - Option 2: Installing on a solid concrete or concrete
block wall*
CAUTION:
Mount wall plate directly onto the concrete surface.
1
Align the wall plate template (D) at the height you determined in the previous step, make sure that it is
level, then tape it to the wall. Use a pencil to mark the lag bolt hole locations (4).
2
Drill pilot holes to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter masonry drill bit. Remove
the template.
3
Insert the concrete wall anchors (U) into the pilot holes and use a hammer to make sure the anchors are
flush with the concrete surface.
4
Align the wall plate (A) with the anchors, insert the lag bolts (T) through the lag bolt washers (S), then
through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall plate.
CAUTION:
* Minimum solid concrete thickness: 8 in. (203mm).
* Minimum concrete block size: 8 x 8 x 16 in. (203 x 203 x 406 mm).
The minimum distance between the top two fasteners cannot be less than 16 in.
You'll need
Wall plate (A)
DX-DRTVM114 Wall Plate Template • Gabarit de la plaque murale • Plantilla de la placa de pared
Top / Dessus / Vista superior
Top / Dessus / Vista superior
Note: For wood frame installations, use
Tools Needed
Outils nécessaires
Remarque : Pour des installations sur
des structures en bois, utiliser d'abord
Herramientas requeridas
un localisateur de montants pour
détecter un montant en bois.
Nota: para las instalaciones en marcos
de madera, use primero un localizador
de viga para ubicar las vigas de pared.
Wall plate template (D)
To prevent property damage or personal injury, never drill into mortar between blocks.
Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (T).
3 in.
(75 mm)
Pencil
Edge-to edge
stud finder
Important: Make sure that the
lag bolts are inserted into a wood
stud. The distance between two
studs is typically 16".
V1 13-0671
U (4)
S (4)
3/8" masonry
drill bit
Drill
T (4)
1/2" socket wrench
Level
Tape