AGS Parksafe Control Panel 설치, 운영 및 유지보수 매뉴얼 - 페이지 11
{카테고리_이름} AGS Parksafe Control Panel에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Parksafe Control Panel 20 페이지. Ventilation control panel
AGS Parksafe Control Panel에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (16 페이지), 설치 및 운영 매뉴얼 (16 페이지), 설치 운영 및 유지보수 (16 페이지)
페이지 인쇄
Installation, Operation & Maintenance
Operation
First Power Up
Upon connecting mains power, the ParkSafe controller will 'warm up' for approximately one minute. During this
time, the screen will display an 'initialising' message. After the controller has initialised, the system will begin
searching and establishing signals with any connected ParkSafe Detectors.
Alarm Indications
System OK
System under normal/safe operating condition.
System in 'Pre-Alarm' condition
When gas levels reach pre-alarm values.
System in 'Alarm Delay' condition
When gas reaches dangerous alarm values.
System in Alarm condition
Gas levels beyond the alarm delay condition.
Temperature Indication
All outputs will remain active until the temperature (monitored by ParkSafe detectors drops below 4°F of the specified threshold –
adjustable in the configuration settings.
Temperature Status & Icon*
Temperature has exceeded pre-set value.
Silence & Reset Buttons
To silence the internal buzzer in alarm – press the Silence button on the front of the controller.
This will also silence any external audio strobe/sounders connected to the controller.
If the system reaches alarm condition – the controller will need resetting when the gas levels return to a safe
concentration. Check the detector status to identify the gas detected and if levels have returned to a safe
condition - reset the system.
Rev: 20
ParkSafe Controller
All outputs normal/off
▪
Output-1 On
▪
Damper (Selectable On/Off)
▪
0-10V output: 5v
▪
Output-1 On
▪
Output-2 On
▪
Damper (Selectable On/Off)
▪
0-10v output: 10v
▪
Output-1 On
▪
Output-2 On
▪
Alarm On
▪
Damper On
▪
0-10v output: 10v
▪
Gas detector ID shown
▪
Internal buzzer will sound
▪
Output-1 On
▪
Output-2 On
▪
Damper On
▪
0-10v output: 10v
▪
11