AGS Merlin 1000S+ 사용자 설명서 - 페이지 3
{카테고리_이름} AGS Merlin 1000S+에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Merlin 1000S+ 12 페이지. Gas and electric isolation controller
AGS Merlin 1000S+에 대해서도 마찬가지입니다: 설치 운영 및 유지보수 (12 페이지)
페이지 인쇄Merlin 1000S+
1
General Information
The Merlin 1000S+ is a gas shut off, gas detection & electrical isolation utility controller.
The system comprises of a control panel and a gas pressure sensor. The Merlin 1000S+ can
receive connections from remote emergency shut-off buttons, gas detectors and a CO2
monitor. It can also be integrated with a BMS and fire alarm.
It is recommended that the user reads this guide before using the system. Please do NOT
attempt to operate the unit until the contents of this document have been read and are
thoroughly understood.
1.1
Panel Mounting
The control panel is designed for surface mounting using 4 mounting screws. Removing the
cover on the panel gives access to the circuit board. The PCB should be removed before
drilling entry holes into the case.
A flush mount kit is available, comprising of a mounting bracket and decorative surround strip.
Contact your supplier for more information.
This device requires a continual supply of electrical power – it will not work without power.
This device should not be used to substitute proper installation, use and/or maintenance of fuel burning
appliances including appropriate ventilation and exhaust systems.
Your product should reach you in perfect condition, if you suspect it is damaged, contact your supplier.
Information on waste disposal for consumers of electrical & electronic equipment. (EEE)
When this product has reached the end of its life it must be treated as Waste Electrical & Electronics Equipment
(WEEE). Any WEEE marked products must not be mixed with general household waste, but kept separate for
Please contact your supplier or local authority for details of recycling schemes in your area.
Rev: 06
05-19
Important Warning Statements
Never ignore your device when in alarm.
the treatment, recovery and recycling of the materials used.
User Guide
3