Galvin Specialised CliniLever Lead Safe TM-SHWX 제품 설치 매뉴얼 - 페이지 4
{카테고리_이름} Galvin Specialised CliniLever Lead Safe TM-SHWX에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Specialised CliniLever Lead Safe TM-SHWX 4 페이지. Stainless steel shower mixer
페이지 인쇄
TROUBLESHOOTING
PROBLEM
Wall shower is dripping water
Leak from behind body
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty
Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied.
Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but
not limited to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download
from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free
from operational defects in workmanship and materials for the warranty period as shown on the schedule in the
manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any defective
products manufactured by Galvin Engineering without charge, so long as the terms of the Manufacturer's
warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for
breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other
property which is damaged if this product does not work properly, other costs resulting from labour charges,
delays, vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions,
chemical, electrical or any other circumstances over which Galvin Engineering has no control. This warranty
shall be invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or
alteration of the product.
CAUSE
Headworks are worn or
damaged
Insufficient sealant
Version 1, 7 May 2020, 4 of 4
Version 1, 7 May 2020, 4 of 4
RECTIFICATION
Remove and inspect the headworks,
remove debris and/or replace o-rings or
parts if damaged
Apply more thread tape or sealant to
create a better seal
Version 3, 7 May 2020, Page 4 of 4