Galvin Specialised CliniLever TC57SC1C 제품 설치 매뉴얼 - 페이지 2

{카테고리_이름} Galvin Specialised CliniLever TC57SC1C에 대한 제품 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Specialised CliniLever TC57SC1C 4 페이지. Healthcare tapware

페이지 인쇄

PRE-INSTALLATION - Mounting Details

Hole Centres



Hole centres must be at 215mm ±0.5mm, this

is critical to ensure easy installation



Wall spuds must be 15BSP MI and protrude

from the finished wall by no more than 15mm

Note: In some situations a male thread connection

on the tap may be more suited. If so, please

INSTALLATION

IMPORTANT: Galvin Specialised products must be installed in accordance with these installation

instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water

and/or electrical supply conditions must also comply to the applicable national and/or state standards.

Failing to comply with these provisions shall void the product warranty and may affect the performance of

the product.

1. Fit wall flange



Remove the maintenance tails from the

CliniLever

body and take the wall flanges out of

the packaging.



Slide the wall flanges over the maintenance

tails, ensuring supplied o-rings are in the rear

groove of the flange.

150

NOM

155

7 LPM

LAMINAR

265

FLOW

AERATOR

2. Fit maintenance tail



Fit the maintenance tail (with the wall flange) to

the wall spud and fasten with the supplied 12mm

allen key. We recommend using thread tape or

equivalent to ensure the connection does not

leak.

Version 2, 2 June 2017, 2 of 4

215

1/2" BSP FI

ISOLATION

VALVE

SERVICEABLE

INLINE FILTER