Galvin Specialised CliniLever TCWMJ80PC 매뉴얼 - 페이지 2

{카테고리_이름} Galvin Specialised CliniLever TCWMJ80PC에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Specialised CliniLever TCWMJ80PC 4 페이지. Healthcare tapware

페이지 인쇄

PRE-INSTALLATION -

Wall Spud

− Wall spuds must be 15BSP MI and protrude from the finished wall by no more than 15mm

Note: In some situations a male thread connection on the tap may be more suited. If so, please

contact Galvin Specialised on 1300 514 074.

INSTALLATION

IMPORTANT: Galvin Specialised products must be installed in accordance with these installation

instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water

and/or electrical supply conditions must also comply to the applicable national and/or state standards.

Failing to comply with these provisions shall void the product warranty and may affect the performance of

the product.

1. Fit washing machine body

−

Fit the washing machine body assembly with

the wall flange to the spud and fasten with a

spanner.

−

We recommend using thread tape or

equivalent to ensure the connection does not

leak.

−

DO NOT tighten the body by using the top

assembly.

MOUNTING DETAILS

Version 2, 18 July 2017, Page 2 of 4

2. Fit handle

−

Ensure the spindle is in the closed position

and firmly press the CliniLever

onto the spindle in the desired orientation.

−

Check CliniLever

It should turn freely for a full ¼ turn.

−

Secure the handle in position using the

supplied washer and stainless steel cap

screw.

lever handle

lever handles for operation.