Dynisco UPR900 애플리케이션 및 설정 매뉴얼 - 페이지 3

{카테고리_이름} Dynisco UPR900에 대한 애플리케이션 및 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynisco UPR900 13 페이지.

Strain Gauge Connection & Calibration 

UPR900 & ATC990 

Transducer Wiring 

For 6 wire Dynisco Transducers and test box

Input 1 

Terminal

Strain Gauge Input Settings 

1. In Input Configuration, select Input I or 2, then choose Strain Gauge as the Input Type (this is the default type). 

2. Choose appropriate Engineering Units such as KGcm, Mpa (Mega Pascal), psi or bar (or none). 

3. Select number of decimal places to display (remember the display has a maximum of 5 digits including any decimal 

places). 

4. Enter a value for Scale Range Upper Limit (this would equate to the sensor maximum), and the Scale Range Lower Limit 

(this would equate to the sensor minimum – typically zero). 

5. There is a filter time for signal noise. 

6. Select Input Failure mode as High or Low (makes alarms / control behave as thought the input is above maximum range 

or below minimum range if the signal is lost). 

7. Select Peak detection to Maximum, Minimum or Disabled (default). This adds an extra Operator Mode screen to display 

either the highest or lowest input value seen since it was last reset. Reset performed at this screen by pressing UP & 

DOWN simultaneously. It can also be reset via a digital input if fitted. Four digital (logic) inputs are now standard on 

UPR900, and optional on ATC990. 

Colour 

Red 

Signal + 

Black 

Signal ‐ 

White 

Excitation + (10VDC +/‐

7%) 

Green 

Excitation ‐ 

Blue 

Calibration Relay (R‐CAL) 

Orange 

Calibration Relay (R‐CAL) 

Function 

Terminal

Input 2 