Galvin Specialised Safe-Cell 50120C 설치 매뉴얼 - 페이지 2
{카테고리_이름} Galvin Specialised Safe-Cell 50120C에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvin Specialised Safe-Cell 50120C 4 페이지. Manual prison tapware
페이지 인쇄INSTALLATION
IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and
in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply
conditions must also comply to the applicable national and/or state standards. Failing to comply with these
provisions shall void the product warranty and may affect the performance of the product.
1. Disassembly
− Disassemble components
− Separate body washer, cartridge and locknut
3. Fit locknut
− Fit locknut and tighten onto the cartridge,
ensuring fiber washer seals have a similar
tension to the conventional jumper valve
headpart.
5. Fit dress flange with anti-rotation pin
−
If the anti-rotation option is required, fit dress
flange onto locknut and mark the wall. Remove
the flange and drill 3/16" hole 10mm deep.
−
Replace the flange and screw in the grub screw
to lock.
Version 1, 10 November 2016, Page 2 of 4
2. Fit cartridge
−
Fit ceramic cartridge in to the wall body.
body washer
−
Do not over tighten and do not use spindle to
tighten.
4. Fit dress flange
−
Fit dress flange onto the locknut and tighten.
6. Fit lock sleeve
−
Fit lock sleeve and tighten to lock entire unit in
position.
Fit