Dynisco TPG553 사용 설명서 - 페이지 3

{카테고리_이름} Dynisco TPG553에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynisco TPG553 11 페이지. Melt pressure gauges

DYNISCO PG500 Series

1. INTRODUCTION

The Dynisco PG540/PG550 Series pressure gauges are highly

engineered, electronic devices. With proper installation and handling

these units will provide years of care-free service.

The tip of the gauge consists of a stainless steel diaphragm. Care must

be taken to protect the diaphragm from severe abrasion, dents and

gouges. During storage the protective cap supplied with the unit

should be left in place.

1.1

The gauge probe is machined to tight dimensional tolerances. To avoid

damage on installation, the mounting hole should be carefully

machined and checked for the correct dimensions.

A set of mounting hole machining tools is available (P/N 200925) to

assist in preparation of the mounting hole.

The mounting hole should conform to the recommended dimensions

shown in Figure 2, below.

Fig. 2

Gauge Probe Mounting Hole

1 1 1 1 1