Corally TOROX 185 사용 설명서 - 페이지 6

{카테고리_이름} Corally TOROX 185에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Corally TOROX 185 8 페이지.

페이지 인쇄

ESC PROGRAMMING

1. Programming The ESC With The Set Button

FACTORY RESET

• Restore the default values with the SET button

Press and Hold the SET button for over 3 seconds anytime when the throttle trigger is at the neutral position (except

during the ESC calibration and programming) can factory reset your ESC. RED & GREEN LEDs flash simultaneously

indicating you have successfully restored all the default values within your ESC. Once you power the ESC OFF, and

then back ON, the settings will be back in the default mode.

LED STATUS

1. During the Start-up Process

• The RED LED flashes rapidly, showing indications that the ESC doesn't detect any throttle signal or the neutral throt-

tle value stored on your ESC may be different from the current value stored on the transmitter.

• The GREEN LED flashes "Number" times indicating the number of LiPo cells you have connected to the ESC.

2. In Operation

• RED & GREEN LEDs die out when the throttle trigger is in throttle neutral zone.

• The RED LED turns on solid when your vehicle runs forward. The GREEN LED comes on when pulling the throttle

trigger to the full (100%) throttle endpoint.

• The RED LED turns on solid when you brake, the GREEN LED will also come on when pushing the throttle trigger to

the full brake endpoint and setting the "maximum brake force" to 100%.

• The RED LED turns on solid when you reverse your vehicle.

3. When Some Protection is Activated

• The RED LED flashes a short, single flash and repeats (☆,☆,☆) indicating the low voltage cutoff protection is acti-

vated.

• The GREEN LED flashes a short, single flash and repeats (☆,☆,☆) indicating the ESC thermal protection is activat-

ed.

• The GREEN LED flashes a short, double flash and repeats (☆☆,☆☆,☆☆) indicating the MOTOR thermal protection

is activated.

MANUFACTURER :

Team Corally hereby declares that the speedcontroller system type TOROX 185 complies with the Directive

2014/53/EU.

The full text of the EU Declaration of Conformity is available at the following Internet address:

www.corally.com

Team Corally, Geelseweg 80, B-2250 OLEN, Belgium, [email protected]

SIMPLIFIED DECLARATION OF CONFORMITY

PLEASE NOTE :

• For easy recognition, the motor beeps at the

same time when the GREEN LED flashes.

• When "N" (the number) is equal to or bigger

than 5, we use a long flash to represent "5".

For example, the GREEN LED flashes a long

flash (and the motor beeps a long beep at the

same time) indicating you are in the 5th pro-

grammable item; if the GREEN flashes a long

flash and a short flash (and the motor beeps a

long beep and a short beep at the same time)

indicating you are in the 6th programmable

item; a long flash and two short flashes ( a

long beep and two short beeps at the same

time) indicating you're in the 7th programma-

ble item and so on.