Galvo Shed GVO 1515 조립 지침 매뉴얼 - 페이지 6

{카테고리_이름} Galvo Shed GVO 1515에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvo Shed GVO 1515 8 페이지. Sloping roof shed

STEP 6

END WALLS

Cap 1 sheet

with

1485mm channels.

Fix the channels at the corners and every 2nd rib in between.

Make sure you put at least two fixings up through the underside

of the channel into the pan of the sheet.

Perform the same again for the other end.

STEP 7

DOOR BRACES

The door braces can be fitted now or after you have assembled your shed.

Tuck one end of the 'Z' between the bottom channel of the inside of the

door and the sheet. Do the same at the top, overlapping in the centre

behind the padbolt.

If you have a locking 'T' handle you will have to run the 'Z's the opposite

way to the diagram.

Rivet the 'Z's at the ends, and in the centre of the channel it is tucked

under, and through the overlap in the centre. Two or three more fixings will

be required through the door sheeting into the 'Z', but they will need to be

riveted through from the outside of the door for a neater appearance.

You may need to cut or bend the flange at the bottom and the top of the

'Z' if it catches on the door jamb when opening or closing (diagram 1).

DIAGRAM 1

BEFORE

AFTER

YOU WILL NEED

4 x 1980-1830mm sloping sheets

(2 left, 2 right)

4 x 1485mm channels for end walls

(2 per side)

YOU WILL NEED

2 x 'Z' Door braces

Fixings

If you choose to vary from these instructions your warranty will be impaired

CHANNELS

Channels will end 15-20mm

short at tops of end walls

and 10-15mm at bottoms.

ABOVE

Z door braces in position on

the inside of door sheet