Galvo Shed GVO 3030 조립 지침 매뉴얼 - 페이지 4
{카테고리_이름} Galvo Shed GVO 3030에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvo Shed GVO 3030 8 페이지. Gable roof shed
페이지 인쇄
STEP 3
FRONT WALL
Lay down the doors with the sheets attached. Cap the sheets with the 3000mm
channels
. Use the door spacers
F
on top of the 'Z' door jambs
Drill and fix (rivet or screw) the channels at every second rib down through the top.
Attach the door spacers at each end through the 'Z' door jambs and channels.
Put three fixings underneath through the channels into the sheeting pan and the
top and bottom of the door spacers and 'Z' door jambs (see diagram 1).
Fit the padbolt
to the door strap on the outside of the door using wide
P
flange rivets or screws.
PADLOCK KEEPER
ASSEMBLY
KEEPER
WASHER
RIVET
IMPORTANT ADDITIONAL INFORMATION
CHANNELS WITH
F
CUTOUTS
The cutouts go to the inside
of the panel to allow easy
fitment of the end walls on
assembly (page 5).
4
to make sure the door fits the gap (they sit
K
see diagram 1).
N
K
F
TOP
CHANNELS
The higher side of the channel goes
to the inside of the shed. It is very
3
important to include the fixings on the
underside of all the channels as they
are structural (except roof channels).
BOTTOM
YOU WILL NEED
F
2 x 3000mm 'U' channels with ends cut
K
2 x 1586mm door spacers
P
3 x padbolts
K
P
CHANNEL
Fix through the top and bottom of the channels into the door
jamb and spacer. The door jamb goes on inside of the channel.
OUTSIDE
INSIDE
If you choose to vary from these instructions your warranty will be impaired
Channels will come short
of the ends of the sheeting by
10-15mm on all panels.
F
SPACER
GALVO TIP
To hinge the door of your shed on
the opposite side, simply put the
top channel on the bottom and
the bottom channel on the top.
Put the padbolt on the door
before erecting the panels.
It will stop your garage door
swinging around!