Galvo Shed GVO2315 매뉴얼 - 페이지 3

{카테고리_이름} Galvo Shed GVO2315에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galvo Shed GVO2315 4 페이지. Sloping roof garden shed

페이지 인쇄

GVO2315

page 3 -

2: Back Wall

You need:

2 x (e) Channels



3 x (a) Sheets



(e)

3: Roof

You need:

2 x (e) Channels



3 x (a) Sheets



2 x (j) "L"s



4: End Walls

You need:

2 x (f) Channels



2 x (b) Sheets



(b)

(f)

If you choose to vary from these instructions your warranty will be impaired.

(j)

(e)

(a)

(e)

(j)

(a)

(f)

Channels will end

20 - 30mm short

at tops of end

walls and 15 - 20

at bottoms

A. Join 3 (a) sheets together with 2

fixings through the overlapping

ribs making sure the ends of the

sheets are flush.

B. Cap sheeting with (e) channels .

C. Fix the channels through the

end ribs and every 2nd rib be-

tween.

D. Make sure you put at least 1 fix-

ing per sheet up through the

underside of the channel into

the pan of the sheet.

A. Join 3 (a) sheets together same as

the back.

B. Cap sheeting with (e) 2255mm

channels.

C. Fix the channels every 2nd rib but

not the corners at this stage

D. Place the short flange of the "L"

on top of the rib at 1 end. Make

sure ends are flush with sheeting

and put 1 fixing in the centre to

hold the "L". Fix the corners

through the channels and 1 more

between the corner and the cen-

tre fixing. Perform the same at the

other end. 5 fixings ea "L"

A. Join 2 Left (b) sheets together

to give a slope at the top.

B. Cap sheeting with (f) 1485mm

channels.

C. Fix the channels through the

end ribs and every 2nd rib be-

tween.

D. Make sure you put at least 1

fixing per sheet up through the

underside of the channel into

the pan of the sheet.

E. Perform the same again for

the Right side.