Coram Showers OFFSET QUADRANT 매뉴얼 - 페이지 4

{카테고리_이름} Coram Showers OFFSET QUADRANT에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coram Showers OFFSET QUADRANT 8 페이지.
Coram Showers OFFSET QUADRANT에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (9 페이지)

페이지 인쇄

Push fit the 'short flipper seals' onto the top and

bottom edges of both fixed panels - flush against

the metal profile. Ensure the flipper seal 'flaps' are

on the inside of the fixed panels. Note: Wetting

the glass with water will help fit the seals.

Outside

face of fixed

panels

Out-

side

face of

fixed

panel

Position the fixed panels into the wall channels and slide down

so that they fully slot onto the end mouldings of the bottom rail.

Inside the enclosure, ensure the panels sit in the 'fixed panel

brackets', slide the fixed panel brackets along the rails and

position under the panels as shown.

Out-

side

face of

fixed

panel

Fixed

panel

bracket

13mm

Inside

Position the top rail onto the top of the

'fixed panels'. Adjust the position of the

fixed panel brackets as required.

Line up the holes and fix the top rail

using 2 x 13mm screws.