Dynojet 4-126 설치 지침

{카테고리_이름} Dynojet 4-126에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynojet 4-126 4 페이지. Ignition quickshifter

페이지 인쇄

4 - 1 2 6

I n s t a l l a t i o n I n s t r u c t i o n s

PARTS LIST

Quickshifter Stand Alone

Installation Guide

Dynojet Decal

Cable Tie

Velcro

Alcohol Swab

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

2191 Mendenhall Drive North Las Vegas, NV 89081

1-800-992-4993 www.dynojet.com

Read this instruction manual before fitting and operating your product

PRECAUTIONS:

When installing this product it is advisable to position the motorcycle/vehicle so

it cannot cause injury or damage by falling over/rolling forwards or backwards.

The use of a paddock stand is ideal or if necessary chock the wheels.

Ensure that the ignition supply is switched off at all times unless instructed

otherwise within this manual.

When removing or adding electrical cables to the vehicle battery or wiring

harness always remove the negative earth cable/terminal before the positive

cable/terminal.

Replace the negative earth cable/terminal last to avoid

shorting the electrical system.

When mounting the components ensure that the units are protected from

excessive vibration and the environmental elements, and that they are securely

mounted.

Be careful not to bend or pull the wires exiting the module as this could

compromise the weather proofing causing water to enter the module.

When routing electrical cables ensure the cables cannot become trapped or

pinched which could result in malfunction and secure with cable ties where

necessary.

TROUBLESHOOTING

1. No power-up - Check for incorrect battery terminal connections, blown

fuses, poor negative battery terminal connections. Check for severed or trapped

wires.

2. No quickshifter interrupt - Check the Quickshifter is being operated above

approximatley 3000RPM. Check for correct connection of the Quickshifter

harness connectors with the yellow dots and their associated grey link wire

alignment. Verify the Quickshifter sensor output. Check for severed or trapped

wires. Check that the Quickshifter harness connectors have not been greased

as this will cause a poor electrical connection!

3. Engine misfire - Verify the control unit mounting position and check

for isolation from vibration. Check plug and play connections. Verify ignition

coil type and suitability and correct connection of the Quickshifter harness

connectors with the yellow dots and their associated grey link wire alignment.

Verify the Quickshifter sensor output.

4. For further troubleshooting contact Dynojet.

Quickshifter Installation Guide - 1