GAM CUOCOJET 매뉴얼 - 페이지 6

{카테고리_이름} GAM CUOCOJET에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAM CUOCOJET 8 페이지. Vegetable-cutting machine

SECTION 3. PREPARING THE MACHINE FOR OPERATION

UNPACKING THE MACHINE

The machine is packed in a strong carton box. Open this box from the upper side, as indicated by the arrow, remove the

anti-impact materials and raise the machine, holding it with both hands at the bottom. Free the machine from the protec-

tive nylon wrapping and perform preliminary cleaning of the external surface of the machine, using a soft dry cloth.

SETTING UP FOR OPERATION

Transfer the machine to the place where it is required for operation, bearing in mind its size and the dimensions of the

containers for the products to be processed and for finished products, leaving a sufficient space all around the machine for

movement. The base must rest on a solid, uniform and properly levelled surface. The machine requires no anchoring to the

supporting surface.

INSTALLING DISMANTLED PARTS

To facilitate packing and transportation, certain components of the machine are supplied dismantled. However, tests are

carried out at the factory before shipment to verify that they function correctly when installed.

To install these components, proceed as follows:

− Take hold of the presser lever and pull upwards (C fig.2)

− Rotate the knob (A fig.2) by a half- turn until a click is heard and the released knob itself partially moves out.

− With both hands take hold of and raise the cover (F fig.2)

− On the rotating hub, install first of all an expulsion disk (high-ridge or low- ridge according to requirements refer to

table 2), making sure that the drive pins on the hub are properly inserted in the holes in the disk.

NOTE: The expulsion disk MUST ALWAYS BE INSTALLED so that the disks can operate in the correct position.

If you have to carry out operations that require only one disk, insert only one rotating disk above the expulsion disk. If you

have to carry out operations that require the simultaneous use of two disks (Table 1), insert the following devices in the

order given below:

1° - Expulsion disk (high-ridge or low- ridge)

2° - Fixed grid

3° - Rotating disk

FOR OPTIMUM USE OF ALL TYPES OF ROTATING DISKS AND, IF REQUIRED, SIMULTANEOUS USE OF DISKS

WITH FIXED GRIDS REFER TO TABLE 1, WHERE ALL POSSIBLE FUNCTIONAL COMBINATIONS ARE INDICATED.

ESPULSORE BASSO

LOW-RIDGE XPULSION DISK

UNTERE AUSSTOSSCHEIBE

415010 en ma 2017-02

SCHEMA DI ACCOPPIAMENTO DISCHI

COMBINATIONS OF DISKS

SCHEIBENKOMBINATIONSSCHEMA

DISCO ROTANTE

ROTATING DISK

ROTIERENE SCHEIBE

DISCO FISSO

FIXED DISK

FESTE SCHEIBE

DISCO ESPULSORE

EXPULSION DISK

AUSSTOS SCHEIBE

ESPULSORE ALTO

HIGH-RIDGE EXPULSION DISK

OBERE AUSSTOSSCHEIBE