GAM SX4 FOUR Gobo 사용 설명서

{카테고리_이름} GAM SX4 FOUR Gobo에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GAM SX4 FOUR Gobo 6 페이지.

SX4

When using a DMX device with a discharge lamp such as CDM or an HMI, it's suggested that you separate the power circuit for the discharge

lamp from the DMX control device. When using DMX controlled units such as an Indexing TwinSpin™ or SX4® Gobo Changer or DMX Loop Tray,

the "noise" from the discharge lamp ballast may cause some interference and or damage the electronics. For best results we recommend

providing separate line voltage to the DMX devices and the discharge light fixture.

Four channel setting switches are on the control box. The MODE switch is the left one and nearest the red LED power

indicator. The right hand switch is the X1 DMX.

Address then X10 and X100

It is powered by 24 volt DC and controlled by DMX512, either from most color scroller power supplies or a standalone power

supply. Once powered, the unit will show a red power LED to indicate the power is on. The unit is also fitted with a green

LED which indicates the status of operation. After it is powered, the unit needs to initialize to find the home position of the

gobos. This takes about 2 seconds during which time the green LED will flash. Once the home sensing is complete the

flashing will stop. If the LED is not lit then DMX is not present. If the LED continues flashing, it means there has been a fault

detecting the sensor and the unit operates but without correct index positioning.

MODE

FOUR & SIX GOBO CHANGER OPERATING INSTRUCTIONS

--------------- CAUTION ----------------

DMX CHANNELS

Red Green

X100

MODE

FUNCTION

Standlone: slect one gobo for focus

DMX gobo select by fader

DMX Vgobo select - speed & position

Standalone: speed, direction, timed

Standalone: 2 to 6 gobos, timed

Standalone: continuous rotate, set speed

DMX controlled rotation only

DMX control index / rotate one fader

DMX index/rotate on two faders

16 bit indexing / 10,000 positions

Page 1 of 6

X10