AGS Mini Merlin 설치 운영 및 유지보수 - 페이지 12

{카테고리_이름} AGS Mini Merlin에 대한 설치 운영 및 유지보수을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Mini Merlin 20 페이지. Ch4 co: dual gas detector methane & carbon monoxide
AGS Mini Merlin에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 설치 및 운영 매뉴얼 (16 페이지)

페이지 인쇄

Installation, Operation & Maintenance

OPERATION

First Power Up

When electrical power is supplied, press and hold the Touch button, the device enters a

stabilisation phase for approximately one minute – during this period the device is not

operational. If the mini-merlin has been configured to 'auto reset' – your device will power up

automatically when electrical power is supplied.

Reset the Device

To reset after an alarm - press the Touch button once.

If the device enters an alarm state, the gas level indicator will remain red to alert the user that a

high/dangerous level of gas has been detected, until the device is reset.

Manual Operation Test

This option gives the user the opportunity to test each output/contact in response to gas.

Press and hold the Touch button during normal operation.

Display Overview

The user can choose whether to have the audible buzzer sound when gas levels are detected!

For more information see section 'Auto Reset & Buzzer switches'.

Power Off

To turn your device off, remove / isolate electrical power supply.

When power is removed manually or due to an unpredicted power failure the CO and NG BMS circuit will

change state switching off boilers/appliances via a limit switch if configured to do so!

Rev: 20 12-20

Mini-Merlin