AGS Mini Merlin CH4CO 사용자 설명서 - 페이지 10
{카테고리_이름} AGS Mini Merlin CH4CO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Mini Merlin CH4CO 16 페이지. Dual gas detector, methane & carbon monoxide gas
AGS Mini Merlin CH4CO에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (16 페이지)
페이지 인쇄MINI MERLIN CH4CO
8.
Power On & Off
How to turn your device ON
Supply 110-120vAC mains to the [POWER/LINE IN] terminal.
Press and hold the touch button on the front of the unit for 3 seconds.
After initial warm up, the screen will show both NG and CO levels in the area.
To switch your device off - remove or Switch Off the mains power supply.
9.
Building Management System Integration
This device can be integrated with a Building Management System (BMS), a home alarm
system, or be used as part of a boiler low voltage safety limit to make or break a circuit on both
gases separately, (valve open or valve closed) depending on the system.
These switches can be used for a variety of purposes including triggering alarm contacts,
operating and external relay for multiple appliance shut-down and generating status signals for
a BMS system.
10.
Wiring Applications
Gas Supply Controlled by ~120vAC Solenoid Valve
CAUTION: If you use a gas solenoid valve, please note that
standing pilots will need to be re-lit.
We do not recommend installing a gas solenoid valve with
standing pilots.
Gas Supply Controlled by 24vAC Solenoid Valve
When the GAS VALVE terminal is wired to a normally closed
(NC) gas solenoid valve, the device can be used to isolate
gas supply for multiple appliances.
The diagram shown opposite uses an external transformer (not
supplied) to close a 24vAC gas solenoid valve that could
supply gas to one or more appliances.
CAUTION: If you use a gas solenoid valve, please note that
standing pilots will need to be re-lit.
We do not recommend installing a gas solenoid valve with
standing pilots.
Rev: 08 05-19
USER GUIDE
10