AGS Merlin GDP2 사용자 설명서 - 페이지 8

{카테고리_이름} AGS Merlin GDP2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AGS Merlin GDP2 12 페이지. Safe area gas detector controller
AGS Merlin GDP2에 대해서도 마찬가지입니다: 사용자 및 설치 매뉴얼 (7 페이지), 설치 운영 및 유지보수 (12 페이지)

페이지 인쇄
AGS Merlin GDP2 사용자 설명서
Merlin GDP2
5

Maintenance

To keep your panel in good working order, you must follow these steps:
 DO carefully remove any accumulated dust from the outer enclosure once a month.
NEVER use detergents or solvents to clean your device – this may permenantly or temporarily
damage the panel
NEVER spray air fresheners, hair spray, paint or other aerosols near the device.
NEVER paint the device. Paint will seal vents and interfere with the device.
6

GDP2 Wiring Spec

1.
POWER: Mains Input 110-120VAC.
2.
GAS VALVE: Gas Solenoid Valve Power Output, 110-120VAC.
3.
GAS DETECTOR ZONE 1: 24VDC power supply (purchased separately).
4.
GAS DETECTOR ZONE 2: 24VDC power supply (purchased separately).
5.
EM REMOTE: Remote emergency stop buttons (purchased separately). VOLT FREE INPUT
6.
HEAT SENSOR: Fusible Links (purchased separately). VOLT FREE INPUT
7.
FIRE PANEL (Supplied by others). VOLT FREE INPUT
8.
BMS OUT: output contacts. Normally Open, Common and Normally Closed..
9.
SOUNDER/STROBE: Alarm, 24VDC power supply (purchased separately).
10. AUTO RESET & BMS SELECTION SWITCH
11. ZONE ENABLE/DISABLE SWITCH
Rev: 05 05-19
User Guide
8