Dynojet POWER VISION 3 설치 매뉴얼 - 페이지 3

{카테고리_이름} Dynojet POWER VISION 3에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynojet POWER VISION 3 7 페이지. 2020-2021 honda rubicon/foreman/trx520
Dynojet POWER VISION 3에 대해서도 마찬가지입니다: 설치 매뉴얼 (9 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (8 페이지)

페이지 인쇄
Dynojet POWER VISION 3 설치 매뉴얼

GETTING STARTED

Use the Tune File Wizard to prepare your Power Vision
device with the stock (stk) and tune (djt) fi les needed to
fl ash your vehicle.
1
Connect the Power Vision to the vehicle.
2
Turn the key on. The Power Vision will scan for fi les.
There are three possible fi le states:
File State 1: No compatible tune or stock fi les.
File State 2: No compatible tune fi les.
File State 3: All required fi les found.
3
Gauges are displayed.
Connect the Power Vision to the
vehicle diagnostic port to collect
ECU information. Turn the key on.
FLASHING YOUR VEHICLE
The Power Vision must be paired to the connected vehicle ECU
to function properly.
Note: Once paired to the vehicle ECU, the Power Vision will
not work on another vehicle without purchasing a tune
license.
1
From the Main Menu, select Flash Tune.
2
Select the tune fi le (.djt) and press Enter to view the Tune Info.
The Tune Info screen contains the technical notes showing what
was changed in the tune.
Note: The PV3 fi lters out fi les which are not compatible
with the connected vehicle based on year/trim delivered
direct from the factory and result in varied tune Compat and
CheckSum within the ECU. Additional fi les may be visible
on the device when connected via USB or on the website;
however, the PV3 will only display fi les which directly fi t your
vehicle.
Note: The Dynojet tune fi le (.djt) is a tune fi le which is
different (better than stock performance or the necessary fi le
when bolting on an exhaust, for example); the stock fi le (.stk)
is the direct duplicate of what the OEM shipped.
3
Press Enter to accept the tune, or restore the ECU to original
stock (.stk) fi le, and pair the Power Vision to the vehicle.
Note: Pair to vehicle will only happen on the fi rst fl ash.
4
Press Enter to pair and lock the Power Vision to the ECU and to
begin the fl ash. Do not turn off the key switch or disconnect the
Power Vision during the fl ash.
5
After the fl ash is complete, turn the key off and wait 45 seconds
before turning the key back on to start.
File State 1:
Go to
tunes.dynojet.com/
download stock and tune fi les.
File State 2:
Go to
tunes.dynojet.com/
download tune fi les.
File State 3:
All required fi les found. The Power
Vision is ready to fl ash a tune to the
connected vehicle.
to
to
3