CORBERO ZD19/4R-3 빠른 매뉴얼 - 페이지 5

{카테고리_이름} CORBERO ZD19/4R-3에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CORBERO ZD19/4R-3 14 페이지.

Changing the opening direction

of doors and Panelling

If you refrigerator has top panel (fig. 4), you can mana-

ge in the same way from point 1 to point 6 and then:

7... Unscrew the axle of the upper hing (9 Fig. 4) and

replace it at the opposite side (10 Fig. 4).

8... Remove the little lid put on the opposite side of the

central hinge and use it to cover the new holes left

where the hinge was placed.

For the remaining parts proceed the other way round.

Once finished make sure that all joints close

perfectly well all around the door and chek that the

internal light turns of when the fridge door closes.

How to panel the doors:

If your appliance is provided with metal strips for

panelling and you wish to do so proceed as follows:

1... Remove one of the side strips.

2... Loosen the screws of the remaining strips.

3... Start putting on the panel where you took off the

strip pushing it right up to the end.

4... Replace the strip on this side.

5... Tighten all screws

NOTE: The panel dimensions must be 2 mm. shorter

than the doors. Maximun thickness of the panel is

4 mm.

Fig. 4