GAMA Electronics RF12V-2-ASL 사용 설명서 - 페이지 2
{카테고리_이름} GAMA Electronics RF12V-2-ASL에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GAMA Electronics RF12V-2-ASL 4 페이지. Rf receiver
GAMA Electronics RF12V-2-ASL에 대해서도 마찬가지입니다: 사용 설명서 (4 페이지)
페이지 인쇄
WWW.GAMAINC.COM
Each transmitter has its own unique internal address along with the data as to which button is pressed and transmitted.
The receiver needs to be programmed to respond only to the specific transmitter it is intended to operate with. The
following steps configure the receiver to operate with a particular transmitter. Up to 30 transmitters can be programmed
to one receiver. Please read the entire programming procedure before starting. When the receiver enters program
mode, all previous transmitter addresses that were programmed will be erased from the receiver's memory.
1. Locate the pushbutton labeled "PROGRAM" on the receiver. Press and hold this button until the red LED next to the
program button illuminates (approximately 3 seconds). The receiver is now in the transmitter program mode. Release
the button. At this point all previously programmed transmitter addresses are erased from the receiver's memory.
2. To configure the receiver for a latching output, go to Step 4.
3. To configure the receiver for momentary output, press and release either button on the transmitter once and verify
that the red program LED extinguishes and then illuminates (blinks once). Proceed to Step 5.
4. To configure the receiver for latching output, press and release either button on the transmitter twice and verify that
the red program LED extinguishes and illuminates (blinks twice).
5. Repeat previous step for additional transmitters that will operate with this particular receiver. The red LED on the
receiver will extinguish and illuminate (blink) once for the first transmitter being programmed, twice for the second, three
times for the third, etc. The receiver will not respond to transmitters that have already been programmed. The first
transmitter that is programmed determines the receiver's relay operating mode.
6. The receiver will return to normal mode if no transmitter buttons are pressed for 5-seconds. The red LED on the
receiver will blink rapidly, then extinguish. The receiver is now in the normal mode of operation. This completes the
programming instructions. The receiver will retain all of its programming even when power is removed.
Program Switch
Long Range
Antenna Jack
Programming Instructions
PROGRAM
1
-12V
RF12V-2-ASL
Instruction Manual
Program LED
2
+12V
RF12V-2-ASL
GAMA Electronics, Inc.
www.gamainc.com
Auxiliary Switch
Leads
Page 2 REV A 03/09/20