Dynojet Power Commander FC 설치 지침 - 페이지 3

{카테고리_이름} Dynojet Power Commander FC에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynojet Power Commander FC 5 페이지. Power commander fc, fuel injection module

FIG.A

Remove

FIG.B

FIG.C

FC16052

Remove

www.powercommander.com

Remove the seat.

Remove both side panels below the seat. Remove the mid and lower fairing

panels on both sides. Remove the inner fairing panels just forward of the fuel

tank on both sides (Fig. A).

Loosen the front of the fuel tank. Lift and prop the fuel tank.

Using the supplied Velcro, secure the PCFC module in the tail section just rear

of the bike's battery (Fig. B).

Clean both surfaces with the supplied alcohol swab prior to applying the

Velcro adhesive.

Route the PCFC wiring harness forward along the left side frame rail and

under any frame cross-members.

Secure the PCFC ground wire with the small ring lug to the negative (-)

terminal of the bike's battery.

Locate and unplug the Fuel Injector sub-harness connector just below the fuel

tank on the left side of the bike (Fig. C).

This is a BLACK 6-pin connector.

2014 Honda CB650F/CBR650F - PCFC - 3