Main Access 200101T 조립 지침 - 페이지 2

{카테고리_이름} Main Access 200101T에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Main Access 200101T 2 페이지. Deck conversion kit

Step 3: Insert the smaller end of the handrail

connector into the top of the lower handrail.

Step 5: Place upper handrail down over the

handrail connector.

Step 7: Pool Installation

Note: Two people are required for installation.

A total weight of approximately 100 lbs. is

required to keep the step from moving once in

place under water. With the assistance of another

person, carefully place the step in the pool. Place

the two sealed bags of sand (not included) in

ballast bags (M) over the ballast tray (D) to hold

the step in place. Walk step back against the pool

wall to prevent swim behind hazards.

*Optional* Purchase (2) Anchors (#200888) to weigh

down the Step. Sand not included.

For Questions Regarding Installation, Please Contact Main Access Customer Service 1-888-333-1134

Deck Conversion Kit

Model #200101T Assembly Instructions

Step 4: Place deck connector on the upper handrail

and place into the hole on the top step.

Step 6: Drill #14 x 1 1/4" screws into handrails

through all upper and lower risers.

Step 8: Deck Mount Installation

With the step in position close to the pool wall,

slide the deck connectors (H) installation position

on either the pool top seat or pool deck. Secure to

the deck with two #8 x 1" screws (N). Use a

minimum of two screws per deck connector.

Secure each deck connector (H) to each upper

handrail (E1) by using a single #8 x 1" screw.

All Finished!