AFL ASCEND 설치 지침 - 페이지 4
{카테고리_이름} AFL ASCEND에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AFL ASCEND 4 페이지. Splice cassette
AFL ASCEND에 대해서도 마찬가지입니다: 설치 지침 (4 페이지)
페이지 인쇄SPLICE CASSETTE ASSEMBLY
1.
Route the pigtail fibers inside of the splice cassette. Create two-and-a-half (2.5) loops around the bottom of cassette by rotating the cassette counter clockwise
(Figure 11).
2.
Mount the splice sleeve holder assembly on the cassette base (Figure 12).
3.
Route the incoming fibers into the cassette on top of the pigtail fibers. Wrap the fiber one (1) time around the base (Figure 13).
4.
Place the cable mounting clip onto the incoming fiber in the correct opening – 3 mm or 900 μm (Figure 14).
5.
Mount the incoming fiber into the module using the mounting clip into the center slot. Cable jacket should extend just beyond the chamber wall (Figure 15).
6.
Place the plastic cover over the module and slide it forward to lock it into place (Figure 16).
Figure 11
Figure 15
To install the cassette into an ASCEND housing, follow the procedure outlined in the ASCEND Cassette Installation Instructions.
Note: A separate cable mounting bracket kit should be used to secure the cable to the side of the housing.
4
Figure 12
Figure 16
(800) 235-3423 • (864) 433-0333 • AFLglobal.com
Figure 13
3 mm
900 μm
Figure 14
INS-01006