Gama Garden GLM 48P Basic 사용 설명서 - 페이지 14

{카테고리_이름} Gama Garden GLM 48P Basic에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gama Garden GLM 48P Basic 19 페이지.

Acquaer Kft.

H-4900, Fehérgyarmat, Szatmári utca 11.

MAINTENANCE AND STORGE

Always remove the spark plug lead before repair, cleaning or

maintenance work. After 5 hours running time, tighten screws and

nuts. Check the oil. The spark plug must be at the highest point on

the mower when it is tilted up.

Clean mower thoroughly after each mowing with cloth or

brush.

Do not spray with water. Keep mower in a dry room.

·Annually (After end of season)

Grinding and balancing the cutter blade. Remove the sparkplug

lead. Fitting and removing the blade require the use of protective

gloves. Unscrew the cutter blade and deliver it to a service

workshop for grinding and balancing. Tighten the screw properly

when reassembling.

Drain fuel from tank to prevent build-ups inside the tank.

Change oil after each season or after 25 hours running time. Run

the engine warm, remove the spark plug lead. Remove the drain

plug from bottom of engine and drain oil. Fill with new oil.

·Cleaning the air filter.

Keep the filter clean and oil saturated. Replace it if broken, cut or with

damaged parts.

IMPORTANT: Never use compressed air to clean the filtering

element.

• Clean around the filter cover

• Release the clip; remove the cover and the foam element.

• Wash the foam element in liquid detergent and water. Squeeze dry

in a clean cloth.

• Saturate the foam element with 2 table-spoons of clean engine oil and squeeze it a

few times to distribute the oil evenly.

• Remove excess oil with a clean cloth.

• Clean the interior of the air cleaner housing from any dust and grass, making sure

that they do not enter the intake manifold.

• Install the foam element in its housing and close the cover.

If the foam element has been replaced, proceed to oil the new filter as described

above in sections.

14/19