Gama Garden GLM-43E 사용 설명서 - 페이지 7

{카테고리_이름} Gama Garden GLM-43E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gama Garden GLM-43E 10 페이지.

페이지 인쇄

-after striking a foreign object. Inspect the machine for damage and make repairs before restarting and operating

the machine;

-if the machine starts to vibrate abnormally(check immediately);

Always mow slopes at right angles to the incline; never mow up and down

Caution: do not touch running cutters.

Never open the guard flap while the motor is still running.

Assembly

Collector part assembly (fig.A1)

1.Press the handle (1) into collector cover(2),

2.place the collector cover on the collector base(3) from above in such a way that all the eyes are positioned over

the hooks.

3.Press the collector cover on the collector base until the hooks engage securely.

4.Inspect：Check that all the hooks are engaged securely.

Assembling bottom handle part(fig.A2)

Put the bottom handle(A) into chassis holes(B), then insert securing screw ST4.7X16 (C) from inside through the

bottom handle, so that both projections catch in the recesses.

Assembling top of handle(fig.A3)

Attaching switch, strain relief and clips(fig.A4/A5)

Fold up switch bracket and position switch on the upper handle element so that the two nubs catch in the holes .

Close switch bracket . Then fasten switch with the two screws ST4X16. fasten switch cable with the clips on the

handle rod.(fig.A4)

Operation

Operating times

Please check noise abatement regulations prevailing in your country.

Inserting power cable into cable holder (fig.A6)

Insert the power cord into the strain relief as shown in the illustration.

Connecting to the mains

The mower operates from any normal household mains supply

(230 Volt AC., 50 Hz), provided with a 13 Amps. fuse.

Note:

Use a residual current device (RCD) rated for a residual current not greater than 30 mA.

Collector (Fig.A8)

Fitting

Lift the deflector guard and hold up, fit the collector.

Removing/emptying

Lift the deflector guard and hold up. Remove collector.

For non grass collection the mower can be used without the collector in position, with the deflector guard in the

down position.

Setting the working depth (Fig,A9)

Stop, release switch lever and wait until the motor stops before adjusting height. The

blades continue to rotate after the machine is switched off, a rotating blade can cause

injury

For the first cutting of the season, a high cutting adjustment should be selected.

You machine has five settings that result to the following cutting heights.

Ⅰ=25mm

Ⅱ=35mm

Important! The front and back wheels must be set to the same height.

Starting and Stopping (Fig.A7)

The blade continues to rotate for a few seconds after the machine is switched off. Allow the

motor/blade to stop rotating before switching "on"again.

Ⅲ=45mm

Ⅳ=60mm

Ⅴ=75mm