AgSense Crop Link Pro 배선 지침 - 페이지 9

{카테고리_이름} AgSense Crop Link Pro에 대한 배선 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AgSense Crop Link Pro 12 페이지. 2017-18 4-20ma inputs and scaled voltage inputs
AgSense Crop Link Pro에 대해서도 마찬가지입니다: 배선 지침 (12 페이지)

페이지 인쇄

Submersible Tank Level Sensor Wiring:

Ashcroft SL17 series 4-20mA sensor

1. Install the Red wire into the 12v Out terminal as shown above.

2. Install the Green and Bare wires into the GND terminal as shown above

3. Install the Black wire into input AN5 4-20mA or AN6 4-20mA terminal as shown above.

4. White wire is not used and can be capped off.

5. Make sure a jumper is installed as shown above or the 4-20mA input will not work.

Note: DO NOT shorten or lengthen the cable on this transducer. This cable contains an air vent

tube and filter that is critical to this transducer functioning correctly – do not modify!!

Page 7