Dynojet 2009 Yamaha FZ1 설치 지침 - 페이지 4
{카테고리_이름} Dynojet 2009 Yamaha FZ1에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynojet 2009 Yamaha FZ1 4 페이지. Power commander
페이지 인쇄FIG.D
FIG.E
FIG.F
22-015 www.powercommander.com
8
Attach the ground wire from the PCV to the negative side of the battery
(Fig. D).
9
Locate the stock O2 sensor in the exhaust. Follow the O2 sensor har-
ness and unplug it from the main wiring harness (Fig. E)..
10
Plug the Dynojet O2 optimizer into the main wiring harness.
The stock O2 sensor will not be connected to anything anymore
11
Install the PCV in the rear section of the trunk (Fig. F).
12
Make sure all the wires are routed properly.
13
Reinstall the main seat and the passenger seat.
Speed input - Pink wire on white 3 pin connector under fuel tank
Temperature input - Green/White wire - same plug as PC
12v source for Auto tune - BLUE wire of tail light connector
2009 Yamaha FZ1 PCV - 4