Gama Sonic GS-101 사용 설명서 - 페이지 3

{카테고리_이름} Gama Sonic GS-101에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gama Sonic GS-101 4 페이지. All-in-one 6w led solar motion security light

Advice: Ideal Pole Height: 6.5 – 13 feet; Ideal Pole Diameter: 1.5 – 2 inches.

If multiple lights are purchased install between 25-40 feet apart for optimal

light spread.

Surface Mount: Make sure the alignment of your mounting location is level and even

for your solar light installation. Drill two holes into your desired installation surface

and place anchors in to the holes. Position the two provided screws through the

holes of the lamp and into the anchors. Tighten the screws to secure the lamp to the

surface.

: There are specific types of screws for different surfaces. If you're unsure of the

Note

appropriate type of screw to use on your desired surface, please consult a professional.

Post Mount: Assemble hardware to fixture housing; slide fixture over light post and

make sure the curved side of the mount hugs the light pole; tighten to desired height

(CAUTION: DO NOT OVERTIGHTEN SCREWS)

and position

(After several years of use, the battery may need replacing)

1. Remove all 10 screws from the underside of the security light.

2. Unclip the battery connector and remove the old battery. Make sure the

new battery is a high quality – 1x Li-Ion Battery pack (3.7 Volt / 4000

mAh) with matching connector.

3. Install the new battery into the battery compartment.

4. Re-assemble by reversing Step 1.

Installation Instructions

Replacing the Battery