HIKOB AZURE LION 사용자 문서 - 페이지 5

{카테고리_이름} HIKOB AZURE LION에 대한 사용자 문서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKOB AZURE LION 14 페이지.

HIKOB AZURE LION

Version 2.0-2466

The HIKOB AZURE LION product is certiﬁed to be compliant with Japan

Radio Law - Article 2 paragraph 1 Item 19.

1.3.3 USA

Information to user This device complies with part 15 of the FCC Rules. Operation is sub-

ject to the following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instruction, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception which can be determined by turning

the equipment off and on, the user is encouraged to try to correct interference by one or more

of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on circuit different from that to which the receiver

is connected.

– Consult the dealer or an experienced radio/TV technician for help.

RF exposure This device complies with FCC RF radiation exposure limits set forth for gen-

eral population. This device must be installed to provide a separation distance of at least

20cm from all persons and must not be co-located or operating in conjunction with any other

antenna or transmitter.

Transmitter Antenna Under Industry Canada regulations, this radio transmitter may only

operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter

by Industry Canada. To reduce potential radio interference to other users, the antenna type

and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is

not more than that necessary for successful communication.

Licence-Exempt Radio Appartus This device complies with Industry Canada licence-exempt

RSS standard(s). Operation is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.

November 2015 Page 5/ 14