HIKOB INJ PH-AC100A 설치 매뉴얼 - 페이지 10

{카테고리_이름} HIKOB INJ PH-AC100A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKOB INJ PH-AC100A 11 페이지.

Installation Guide

INSTALL_GATEWAY-V5

2019/01 Edition

•

The PoE connector stamped IN goes to your IP network.

•

You supply the PoE injector with cables and plugs following your country / area

safety directives for electrical devices.

4.3

Outdoor deployment

The GATEWAY is suitable for outdoor use: the envelope has maximum protection against dust

ingress and is water resistant (IP65).

In case of an outdoor installation and power for the GATEWAY is supplied by a PoE

injector, you will have to pay attention to the standard safety rules installing electrical

devices outside.

Most likely you'll need a technical electrical enclosure to host the PoE, and to supply power.

Some PoE are sold to be useable outdoor, some are sold with an extra IP66 enclosure, when

choosing your equipment, pay attention to the 802.3af-2003 and 802.3af-2009 compatibility

and to operating temperatures as well. HIKOB has some product references to advise, ask

our vendors.

Consider as well other alternatives: you can have the GATEWAY installed outside, and the

PoE inside.

HIKOB provides an industrial connector housing (Amphenol Socapex RJF RB 6, which is

IP67), to be mounted on the Ethernet cable before connecting it to the GATEWAY. This is a

protective sealed and hardened envelope which can be added around any standard RJ45

connector. Choose an Ethernet cable suitable for outdoor use. You don't need tools to equip

your Ethernet cable, just follow these step by step graphical instructions:

Figure 3: Steps to dress the Ethernet cable with the Amphenol connector housing

Pull a Cat.5e Ethernet cable from your electrical cabinet, not going further than 100m long,

to ensure data rate quality. Don't connect it while you're doing the installation.

Mount the Amphenol Socapex on the end of the cable that goes to the GATEWAY

Page 10