Frigidaire LEDB400FEE 사용 및 관리 매뉴얼 - 페이지 15
{카테고리_이름} Frigidaire LEDB400FEE에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Frigidaire LEDB400FEE 20 페이지. Aquasurge technology with speedclean
페이지 인쇄Care and Cleaning
Burn
Hazard
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in
burns.
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher,
check to make sure it is clean so the
dishwasher
will drain properly.
A drain air gap is
usually
mounted
on countertop
and can be
inspected
by removing
the cover. This is not part
of your dishwasher
and is not covered
by
warranty.
Outside--Occasionally
wipe with a mild
nonabrasive
detergent
and water.
Rinse and dry.
Models with
Stainless
Steel Door--
Clean outer door with warm soapy water and a
dishcloth
or sponge.
Rinse with clean water and a
dry cloth. Do not use harsh cleaners.
Inside--The
inside of the dishwasher
is self-
cleaning
with normal
use. If needed,
clean around
the tub gasket
area with a damp cloth.
The filter is self-
cleaning.
A glass
trap located in the
center of the filter
is designed
to
collect
pieces of
broken
glass,
straws,
bones and
pits. To remove
items in glass trap,
grasp handle,
lift
out, empty and
replace.
Note:
Hard water may cause lime deposit
buildup
on the interior
of the dishwasher.
For cleaning
instructions
see "Removing
Spots and Film"
section.
Overfill
Protector--keeps
dishwasher
from
overfilling
and is located in the left front corner of
the tub.
• Clean occasionally
with
household
cleaner
containing
vinegar
or
bleach
to dissolve
any
buildup.
• Overfill
Protector
should
move up and
down freely about one
_
inch. If it does not
move, lift and clean underneath.
15
Property Damage Hazard
Freezing temperatures
may cause water lines
to rupture.
Be sure all supply lines to and
circulating lines within dishwasher
are
_rotected.
Failure to do so could result in property
damage.
Winterizing
A dishwasher
left in an unheated
place should
be
protected
from freezing.
Have a qualified
person
do the following:
To Disconnect
Service:
1. Turn off electrical
power to the dishwasher
at
the supply source
by removing
fuses or
tripping
circuit breaker.
2. Shut off water supply.
3.
Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4.
Disconnect
drain line from pump and drain
water into pan.
Note: See Installation
Instructions
for more
details.
To Restore
Service:
1. Reconnect
the water,
drain, and electrical
power
supply.
2. Turn on water and electrical
power supply.
3.
Fill both detergent
cups and run dishwasher
through
a ULTIMATE
SCRUB
cycle.
4. Check
connections
to make sure they do not
leak.
Note:
See Installation
Instructions
for more
details.