Hikobike RANGLER 사용자 설명서 - 페이지 9

{카테고리_이름} Hikobike RANGLER에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hikobike RANGLER 15 페이지.

NORMAL OPERATION

Press and hold the ON button for 2 seconds to power on the display. Pressing and holding the ON

button again for 2 seconds will turn OFF the display. If the bike is not used after 5 minutes the

display will turn OFF automatically.

ASSIST MODE SELECTION

Press the up or down arrows to select the desired level of assistance from the motor. Level 1 is the

lowest and Level 5 is the highest. At Level 0 there will be no assist from the motor while pedalling.

STOPPING THE MOTOR

All the following will stop the motor:

Stopping pedalling

Pulling on either brake lever

Pressing the thumb throttle whilst pedalling

Pressing the down arrow to PAS 0

HEADLIGHT / REARLIGHT AND DISPLAY BACKLIGHT SWITCH

A quick press of the ON button will turn on the backlight of the display and the head and taillight.

Press the ON button to turn them off.

WALK ASSISTANCE 6KM/HR

Press and hold the (down) Button. The ebike will move at 6Km/hr and be in WALK mode. Once the

button is released the ebike will stop.

BATTERY CAPACITY INDICATOR

When the battery status is normal, a certain number of the battery LCD segments at the top left

of the screen will light up, according to the level of charge. A percentage charge figure shows

beside it. If the indicator shows the battery is very low the battery needs to be charged

immediately. It is not recommended to discharge the battery completely while riding as this can

decrease the overall life of the battery.