CORBERO CCH358W 사용 지침 및 유지 관리 매뉴얼 - 페이지 3

{카테고리_이름} CORBERO CCH358W에 대한 사용 지침 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CORBERO CCH358W 16 페이지. Horizontal freezer

페이지 인쇄

R600a (ISOBUTANE)

Isobutane is a natural gas that doesn't affect the environment, but it is inflammable. Before con-

necting the equipment to the mains, it is therefore indispensable to check that the cooling circuit

tubing is not damaged. For every 8 grams of cooling fluid, there must be a minimum of 1 cubic metre of

space in the room where the appliance is installed. In the event of a leakage of cooling fluid, make sure

that no flames or other sources of ignition are allowed to get near the leakage point.

INSTALLATION

The equipment must be installed by two people in order to avoid damage to persons and

things. If the equipment has suffered damage

during transport, immediately inform the supplier before

connecting up. Wait at least two hours after installation

before putting the appliance into operation, to allow the

cooling fluid to reach optimum efficiency. The equip-

ment must be put in a dry, well ventilated place. It must

be installed on a flat, stable surface. Adjust the levelling

feet if necessary. There must be at least 90 mm space be-

tween the back of the equipment and the wall (Fig. 1).

Any shelving or cupboards over the appliance must be at

least 800 mm from the cover. Ambient temperature con-

siderably affects energy consumption, so the equipment

shouldn't be exposed to direct sunlight or placed next to

heat sources such as heaters, stoves, cookers, etc. Check

the climate classification on technical data plate on the

back of the equipment.

(operates at ambient temperatures between) +10° C and +32° C

''SN

''N

(operates at ambient temperatures between) +16° C and +32° C

(operates at ambient temperatures between) +16° C and +38° C

''ST

''T

(operates at ambient temperatures between) +16° C and +43° C

Important:

Make sure there is easy access to the power outlet so that the plug can be removed when necessary. If this

isn't possible, connect the equipment to the mains by means of a bipolar switch, in an accessible position,

with a contact opening of at least 3 mm.

ELECTRICAL CONNECTION

Connection of the equipment to a power outlet with an earth contact is a legal requirement. For this

reason the equipment is fitted with a plug with an earth wire for connection to an outlet of the same

type. The manufacturer declines any liability for damage to persons, property or pets due to failure

to observe this rule. Check that the voltage indicated on the technical data plate on the back of the

equipment is the same as that of your mains supply.

How to replace the lamp (only for appliances with lamp) Unplug the equipment or switch off at the main

power switch before replacing the lamp. Only use lamps of the wattage indicated on the lamp shield

(eg. max. 15 W).

(Fig. 1).

- 3 -

9 cm

20 cm