Corbin Russwin CL3380 설치 지침 - 페이지 3

{카테고리_이름} Corbin Russwin CL3380에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Corbin Russwin CL3380 4 페이지. Grade i key-in-lever cylindrical lockset

페이지 인쇄
Corbin Russwin CL3380 설치 지침
To Install Interchangeable Core
(With lever already installed on lock)
A.
Install Tailpiece
Security Disc
Corbin Russwin
Core
Schlage
Core
®
Insert key marked
B.
CONTROL and turn
clockwise approximately
15 degrees.
See Figure 2.
Insert core into lever and return
C.
key to its original horizontal
position locking core in place.
See Figure 3.
Withdraw key.
D.
Test lockset for
correct function
with operating key.
Control key has no
E.
further use in lockset
installation and must
be safeguarded for
return to Security personnel
when installation is complete.
CL3355 Classroom Function Timing
Before installing cylinder:
• Turn Cam so points are up and down, 6 o'clock and 12 o'clock
(See Below)
Cam
Lever Catch
After installing
9
cylinder, test
operation:
• Key should rotate
180° both ways
• If cylinder rotates 360°,
remove cylinder and check cam orientation.
Other product brand names may be trademarks or registered trademarks of their respective owners and are mentioned for reference only.
Cylinder Installation
Tailpiece
Tailpiece set
for all Schlage
Tailpiece
cores except
Set for
Primus
Primus
Figure 2
Figure 3
12
3
9
6
CORRECT
WRONG
To Remove Interchangeable Core
Insert key marked
A.
CONTROL and turn
clockwise approximately
15 degrees. See Figure 4.
Tailpiece
Pull core and tailpiece
B.
completely out of lever.
Make sure lock is unlocked.
Make sure cylinder tailpiece is aligned in same direction as
A.
cylinder bible. Slide cylinder all the way into lever.
• For 6-pin cylinder: Fold retainer at hinge and press fit
retainer halves together as shown.
• For 7-pin cylinder: Break retainer at hinge and discard
spacer section. Also remove black cylinder spacer from
inside of chassis rollback for clearance.
Standard Cylinder Tailpieces
ACTUAL
SIZE
SHOWN
Corbin Russwin conversion kit for Schlage
cylinders with CL3300 lockset.
1. Remove threaded collar and Schlage
12
3
2. Install CL3300 tailpiece
with threaded collar.
(adjust collar for proper
6
end play of plug.)
Install Standard Cylinder
7/8"
11/16"
(22)
6 PIN
®
Figure 4
7 PIN
(17)
®
tailpiece.