MAINLINE MLS10008 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} MAINLINE MLS10008에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. MAINLINE MLS10008 14 페이지. Dual flush round and elogated toilets

ASSEMBLY INSTRUCTIONS

Install Tank (A), (Figure 5)

• Place rubber washer (II) onto bolt (JJ). Insert bolt (JJ)

with washers through hole inside the tank (A).

• Place metal washer (HH) followed by hex nut (KK) onto

bolt (JJ) protruding from bottom of tank (A). Tighten

hex nut (KK) to create a proper and secure seal.

• Attach rubber sealing gasket (LL) to center drain hole

under tank (A).

• Gently place tank (A) on toilet bowl (B) with bolts (JJ)

protruding out underneath.

• Place metal washer (HH) followed by hex nut (KK)

onto the protruding bolt (JJ).

• Tighten hex nut (KK) enough so that the tank (A) sits

flat on the toilet bowl (B).

• Make sure the toilet tank (A) is parallel to the wall and

straight on the toilet bowl (B).

• CAUTION: DO NOT OVERTIGHTEN NUTS. SEVERE

DAMAGE MAY OCCUR.

7. Install Push Button (D)

• Unscrew the tightening nut, which is attached to the button

mechanism.

• Insert the push button body through the tank lid hole. Tighten with

the large nut supplied. (Figure 6)

• Adjust thread rods using locknuts so that the rods are positioned

just over and slightly touching the top of the half flush and full flush

mechanism.

• Note that the half flush is the green tab in the rear and the full flush

is the white tab in front. (Figure 7)

• Note: All toilets come preset and do not need to be adjusted.

Figure 5

Figure 6

Figure 7