Gama Sonic GS-10 사용 설명서 - 페이지 3

{카테고리_이름} Gama Sonic GS-10에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gama Sonic GS-10 5 페이지. Solar security light with motion sensor

5. If you need to install the Solar panel (B) remotely, follow these steps:

Make sure to install the solar panel no more than 15 ft. away from light.

a. Align the Solar panel wall bracket (D) on a wall where you plan to install the Solar

panel, and mark the hole locations with a marker/pencil.

b. Use an electric drill to make two holes in the wall, place provided anchors (E) into

holes, place the Solar panel wall bracket (D) in line with the holes and secure it with

the provided screws (E). Make sure the bracket is installed with the arrow facing UP.

c. Slide the Solar panel (B) into the installed wall bracket (D).

Connect the wire between the solar panel and the light. See Fig. 2

Fig. 2

Operation Instructions

1. The On/Off button (Fig. 3) is located on the bottom side of the light (Fig. 3). To set the light to

operate when it is dark, push the on button. Push again to disable operation.

2. To test that the unit is functioning, cover the motion sensor (Fig. 3) with your hand.

If you test it in daylight, you'll need to wait approx. 15 seconds for the light to turn on.

Fig. 3

On/Off button

Motion sensor