aireRyder F0048 조립 및 설치 매뉴얼 - 페이지 6

{카테고리_이름} aireRyder F0048에 대한 조립 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aireRyder F0048 9 페이지.

페이지 인쇄

Receiver

DIP Switch

Fig. 8

Transmitter

Fig.9

Antenna

4. 3.

Fig.10

Antenna:

DO NOT CUT

OR SPLICE

Safety Cable Hook

Safety

Cable

Hang the safety cable into the safety cable hook.

Antenna

There is a code switch in the transmitter and

receiver. This "DIP Switch" is a 4 key units

(Fig.8). All keys were set at "ON" position in

the beginning. Set the keys to a different

code. Make sure the same numbered keys

are switched "ON" for both DIP switches

(Fig.8a). If the remote controlled fans are

installed than one or the frequency is

interfered, the fan may function abnormally.

Move Ground Wires (a), Outlet Box wires (b), and

Receiver

Motor Wires (c) away from the center of the Hanger

Bracket. Then slide Receiver through Hanger

Bracket as shown, Antenna end first, until it is

Hanger

centered. Finally, cut Motor Wires (c) to length

Bracket

needed for connections.

Receiver

Fig.11

Connect wires:

1) The white (neutral) wire from motor to the white (neutral)

"TO MOTOR N" wire from Receiver with a wire connector.

2) The black (hot) wire from motor to the black (hot)

"TO MOTOR L" wire from Receiver with a wire connector.

3) The blue wire from motor to the blue for "Main Light L" wire

from Receiver with a wire connector.

4) The organge wire from motor to the organge for "Accent

Light L" wire from Receiver with a wire connector.

Hanger

Bracket

5) The white (neutral) wire from Outlet Box to the white "AC in

N" wire from Receiver with a wire connector.

6) The black (hot) wire from Outlet Box to the black "AC in L"

wire from Receiver with a wire connector.

Hanger

7) The ground wire from Outlet Box to the green ground wire

Ball

from the Hanger Ball and the green ground wire from the

Hanger Bracket with a wire connector.

Make sure all of wire connectors are connected firmly.

*** Put all wire connectors and wires carefully up into the

Outlet Box.

Fig.12

Key Hole

Slot

PAGE: 6 / 9

Fig.8a

Code example:

1-ON 2-OFF 3-ON 4-OFF on both DIP

Switches.

Note: If you have two ceiling fans with 2

remote control units, set 2 different

codes for each set of transmitter / Receiver.

Loose canopy screw

and do not remove it ,

push the canopy

upwards to cover

Hanger Bracket

hanger bracket by

inserting canopy screw

Canopy Screw

into key hole slot, then

rotate the canopy till it

Canopy

fixed on the hanger

bracket. finally, Attach

the decorative cap to

canopy, rotate it

Decorative Cap

clockwise until tight.

181128