Dea Digipro 사용 지침 및 경고 - 페이지 7

{카테고리_이름} Dea Digipro에 대한 사용 지침 및 경고을 온라인으로 검색하거나 PDF를 다운로드하세요. Dea Digipro 15 페이지.

페이지 인쇄

In setting mode:

• Press

followed by

times (the admin code length must be the same as above): the sound "BI" indicates that the

• Press

to exit the setting mode.

3.11 Turn on/turn o the anti-removal alarm

In setting mode:

• Press

followed by

• Press

followed by

• Press

to exit the setting mode.

Warning: The built-in buzzer will continuously beep if the photoresistor is exposed to light. The

buzzer will automatically turn o within 60 seconds when the light is no longer detected, or by

entering the admin code.

3.12 Turn on/turn o the bell

In setting mode:

• Press

followed by

• Press

followed by

• Press

to exit the setting mode.

Warning: The bell in ZONE 2 is available if the bell function is on. Press

relay will active once, activating the bell.

Warning: If the bell is enable in ZONE 2, you can't use cards or user codes.

3.13 Adding the master card (ZONE 1 only)

In setting mode:

• Press

followed by

stored, otherwise, if the LED turns red it means there is already saved data, press the

twice to clear the memory, at this point the green LED blinks, then swipe the master card, a

long "beep" will be heard to indicate that the addition was successful.

• Press

to exit the setting mode.

3.14 Enter settings mode swiping the master card

To enter the setting mode:

entry;

• To exit the setting mode, bring back the master card, the LED will turn green and you will hear

Warning: The access control will be locked for 60 seconds after entering a wrong code or the

swiping an invalid card for 5 times (both the keyboard and the card recognition won't be available

during these 60 sec.).

, the yellow LED blinks, then insert a new administrator code two

(the yellow led blinks), then press

, the green LED will blinks indicating that there are no master cards

followed by

, a long "BEEP"

followed by

, a long "BEEP"

followed by

, a long "BEEP"

followed by

, a long "BEEP"

in standby mode, the

key