aireRyder FN52241 매뉴얼 - 페이지 6

{카테고리_이름} aireRyder FN52241에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aireRyder FN52241 8 페이지.

페이지 인쇄

Fig.9

Lock Pin

Collar

Screws

Insert and tighten the two Collar

Screws. Slide Lock Pin into Hanger

Pin until it locks into position.

Fig.12

Tighten the Hanger Ball Screw to the

Downrod.

Receiver

DIP Switch

Fig.14

Transmitter

Fig.15

Antenna

Fig.10

Motor

Wires

Downrod Stand

Cover

Thread the Motor Wires through the

Downrod Stand Cover and Canopy,

as shown. Then thread the wires

through the Hanger Ball.

Fig.13

Hang the fan on Hanger Bracket,

and make sure the slot of Hanger

Ball is snapped into the chip of

Hanger Bracket exactly.

Antenna

There is a frequency-setter respectively in

the transmitter and receiver. This "DIP

Switch" is a 4 key unit (Fig. 14). All keys

were set at "ON" position in the beginning.

Set the keys to a different code. Make sure

the same numbered keys are switched "ON"

for both DIP Switches (Fig. 14a). Take note

that the "ON" position may have different

orientation in each.

Receiver

Hanger

Bracket

PAGE: 2 / 4

Hanger

Ball

Canopy

Fig.11

Tighten the Ground Wire Screw.

Slide the pin in. Slide the Hanger Ball

up into position.

Hanger Bracket

Slot

Tab

Move Ground Wires (a), Outlet Box wires (b), and

Motor Wires (c) away from the center of the Hanger

Bracket. Then slide Receiver through Hanger

Bracket as shown, Antenna end first, until it is

centered. Finally, cut Motor Wires (c) to length

needed for connections.

Fig.14a

Code example:

1-ON 2-OFF 3-ON 4-OFF

on both DIP Switches.

071009