Cord sub-eight 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Cord sub-eight에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cord sub-eight 12 페이지. Sub-eight, high performance subwoofer

Set up

• Do not switch on your CORD subwoofer until all connections are made.

• Connect the subwoofer out on your CORD mi-fi, source amplifier or receiver to the

SUB IN DIRECT  on the subwoofer using a single RCA.

• If your source amplifier does not have a dedicated subwoofer out, connect the line

out to the Line IN  on the subwoofer using a RCA cable, then connect your

speakers directly to the speaker out terminals  on the subwoofer.

• If your source amplifier does not have a dedicated subwoofer out or a line out, then

connect your speaker out from the source to the high level speaker in terminals ,

then connect your speakers to the speaker terminals  on the subwoofer.

• Ensure the vent  is not covered or blocked.

• Connect the AC Power cable to the AC socket  and the AC wall socket.

Basic operation

• To turn ON or OFF, move the main Power switch  to the ON or OFF position.

• To operate, turn the Operation switch  to On or Auto. Auto will permit the subwoofer

to enter a standby mode when no signal is received for a prolonged period.

• To increase the output level, turn the Level control  clockwise. To decrease the

volume turn the Level control counter clockwise. Adjust to remove any distortion.

• To adjust the subwoofer phase and achieve the optimum sound, select 0º or 180º

on the Phase selector . Normal setting is 0º.

• To adjust the crossover point or blend of sound between subwoofers and your other

speakers, adjust the Crossover selector .



Switch off the AC Power before connecting or disconnecting any

accessory cables to ensure correct operation.